Service manual

2-32 8510XF Network Analyzer Systems
Installation
Cable List
Cable List
System cabling for the 8510XF is outlined in the tables below.
Duplicate Listings In these tables, a complete from/to connection list is given for the network
analyzer, the RF source, the LO source, the controller, the left test head, and
the right test head. In other words, each cable is listed twice, and can be
found by looking up the connection from either end. The duplicate listings
make it easier to check the cabling after installation, if a cabling error is
suspected.
In the Notes column, the phrase “duplicate listing” means that the cable has
already been listed once before. The phrase “factory installed” means that
the cable was installed prior to shipment (generally, cables between rack
instruments are factory installed; cables between the millimeter-wave
controller and the test heads are not).
Table 2-7 Cable List (Connections from the 8510C)
From 85101C... To: Notes Cable Type Part No.
IF/display interconnect 85102B -- IF/display interconnect factory installed Multi-pin 08510- 60101
8510 interconnect Millimeter-wave controller --
8510 system bus
factory installed GPIB 8120-3447
(Model 10833C)
From 85102B...
IF/display interconnect 85101C -- IF/display interconnect factory installed;
duplicate listing
Multi-pin 08510-60101
Test set interconnect Millimeter-wave controller -- test set
Interconnect
factory installed Multi-pin 08510-60107
10 MHz in 83651B -- 10 MHz RF output factory installed BNC 8120-5370
Trigger in 83651B -- trigger output factory installed BNC 8120-5370