Service manual

2-20 8510XF Network Analyzer Systems
Installation
Basic System Configurations
Installing the Work
Surface
The work surface is a 1 meter wide table top, to be attached to the system
rack just below the millimeter-wave controller.
1. Extend the lock feet (located at the bottom of the cabinet) to stabilize the
rack.
2. Attach the work surface support rails to the inside of the cabinet.
3. Slide the work surface onto the support rails.
NOTE The 1 meter table top is included in the E7340A and E7350A complete
systems. It is optional in the upgrade kits.
Figure 2-11 Installing the Work Surface