Service manual

8510XF Network Analyzer Systems 2-11
Installation
Unpacking the System
Unpacking the System
Tools Required • 9/16 inch wrench or adjustable-end wrench
• Screwdriver (to pry off packing clamps)
CAUTION When you remove the clamps from the packing crates, be careful not to bend
them; they may be reused when the system is repacked.
Figure 2-2 The Outer Packing Crate
NOTE The figures show a double rack crate. The unpacking procedure is essentially
the same for either a single rack or a double rack crate (differences will be
noted where they occur).