Service manual

8510XF Network Analyzer Systems 7-49
Menus & Commands
New Messages
New Messages
Informational messages
The following informational messages (which are displayed in white letters
on the screen of the 8510C) were created specifically for the 8510XF
firmware.
Table 7-4 Informational Messages (Text Displayed in White)
MESSAGE NOTES
SETTING UP STEP MODE During operation above 50 GHz, the frequencies
of the RF and LO sources must be calculated for
each step; this setup causes a delay.
CONFIGURING FOR LVL DET GAIN CALIBRATION These messages are displayed in connection
with the detector gain cal process.
CALIBRATING LVL DET GAIN, N% DONE. PLEASE WAIT
LVL DET GAIN CAL COMPLETE
SAVING GAIN CAL N% DONE. PLEASE WAIT
VERIFYING GAIN CAL N% DONE. PLEASE WAIT
LOADING GAIN CAL N% DONE. PLEASE WAIT.
SAVING CONV LOSS CAL N% DONE. PLEASE WAIT. These messages are displayed in connection
with the conversion loss cal process.
VERIFYING CONV LOSS CAL N% DONE. PLEASE WAIT.
LOADING CONV LOSS CAL N% DONE. PLEASE WAIT.