Service manual

7-48 8510XF Network Analyzer Systems

Menus & Commands

Unsupported GPIB Commands

LOCTEXTE Select system 1st IF phaselock to external

LOCTNONE Do not phase lock 1st IF NO

LOCTINTE Select system 1st IF phaselock to internal

MULD Multiple source multiplier denominator YES

MULN Multiple source multiplier numerator YES

MULSOFF Turn OFF multiple source mode NO

MULSON Turn ON multiple source mode NO

NORMSTEP Select normal data acquisition cycle NO

OFFF Multiple source offset frequency YES

PULOHIGH Set pulse output active high NO

PULOLOW Set pulse output active low NO

PULP Select pulse proﬁle domain NO

PULW Set width of internally generated pulse YES

QUICSTEP Select the quick step phase lock mode NO

RAMP Ramp sweep mode NO

TRIS Trim sweep value (command exist but value

is ignored)

YES

UNCC Uncoupled channels NO

Table 7-3 GPIB Commands Not Supported by 8510XF

COMMAND FUNCTION ACTIVE FUNCTION?