Service manual

7-44 8510XF Network Analyzer Systems
Menus & Commands
New GPIB Commands
LGCLOADCORR No softkey equivalent Used by Agilent service engineers to load
conversion losscalibration datafrom the test
set EEPROM to the memory of the 8510C.
LGCLOADSCALE No softkey equivalent Used by Agilent service engineers to load
detector gain calibration data from the test
set EEPROM to the memory of the 8510C.
LGCSAVECORR No softkey equivalent Used by Agilent service engineers to save
conversion loss calibration data from the
memory of the 8510C to the test set
EEPROM.
LGCSAVESCALE No softkey equivalent Used by Agilent service engineers to save
detector gain calibration data from the
memory of the 8510C to the test set
EEPROM.
OUTPULGCFRQ<frequency part of
correction table>
No softkey equivalent Used by Agilent service engineers to read
values from the frequency part of the
correction table in the memory of the
8510XF.
OUTPULGCPWR<power part of correction
table>
No softkey equivalent Used by Agilent service engineers to read
values from the power part of the correction
table in the memory of the 8510XF.
POWP1 STIMULUS [MENU] {POWER MENU}
{PORT1 POWER}
Port 1 power (level in dBm can be specified)
POWP2 STIMULUS [MENU] {POWER MENU}
{PORT2 POWER}
Port 2 power (level in dBm can be specified)
PPBLANKON [SYSTEM] {MORE} {RF POWER CONFIG}
{MORE} {BLANKING ON}
Enables port power blanking during
frequency transitionsor port drive transitions.
PPBLANKOFF [SYSTEM] {MORE} {RF POWER CONFIG}
{MORE} {BLANKING OFF}
Disables port power blanking during
frequency transitionsor port drive transitions.
PPBLANK? No softkey equivalent Queries the status of port power blanking
(0 for OFF, 1 for ON).
PPCOUPLEON STIMULUS [MENU] {POWER MENU}
{COUPLE PORTS}
Couples the Port 2 power setting to the
Port 1 Power setting.
PPCOUPLEOFF STIMULUS [MENU] {POWER MENU}
{UNCOUPLE PORTS}
Uncouples the Port 2 power setting from the
Port 1 power setting
PPCOUPLE? No softkey equivalent Queries the status of port power coupling
(0 for OFF, 1 for ON).
PPDETALWAYS [SYSTEM] {MORE} {RF POWER CONFIG}
{MORE} {DET UNL ALWAYS}
Enables detection of “unleveled” errors,
during every sweep.
PPDETNEVER [SYSTEM] {MORE} {RF POWER CONFIG}
{MORE} {DET UNL NEVER}
Disablesdetectionof“unleveled”errorswhile
sweeping.
COMMAND EQUIVALENT SOFTKEY FUNCTION