User`s guide
Table Of Contents
- Legal Information
- Equipment Operation
- General Safety Considerations
- Regulatory Information
- List of Related Publications
- Agilent TechnologiesE4418B Options
- About this Guide
- Getting Started
- Power Meter Operation
- Introduction
- Battery Operation (Option 001)
- Zeroing and Calibrating the Power Meter
- Making Measurements with the AgilentE-Series Power Sensors
- Making Measurements with the Agilent8480 Series Power Sensors
- Making Measurements using Sensor Calibration Tables
- Making Measurements using Frequency Dependent Offset Tables
- Setting the Units of Measurement
- Selecting Units of Measurement from the Softkeys
- Making Relative Measurements
- Setting the Resolution
- Setting Offsets
- Setting Averaging
- Measuring Pulsed Signals
- Setting Measurement Limits
- Selecting a Digital or Analog Display
- Setting the Range
- Configuring the Remote Interface
- Recorder Output
- Saving and Recalling Power Meter Configurations
- How Measurements are Calculated
- Presetting the Power Meter
- Self Test
- Operator Maintenance
- Contacting Agilent Technologies
- Menu Reference
- Error Messages
- Specifications
Index
Symbols
"%" key description 3-12
A
absolute accuracy, specification 5-4
accessories
xi
accuracy, of power reference
5-5
address
of Agilent Technologies 2-77
of GP-IB 2-53
Agilent Technologies
contacting 2-74
offices 2-77
alphanumeric data
entry window 1-15
modify 3-36
altitude characteristic
5-15
analog display
2-49
"Anlg Mtr Scaling" key description
3-15
arrow keys
1-6, 3-36
averaging
2-38
step detection 2-39
B
"Backlight Off" key description 3-33
"Backlight On" key description
3-33
"Backlight Timed" key description
3-33
basic errors,
2-75
"Battery" key description
3-32
battery operation
2-3
backlight 2-4
battery status 2-3
carry case 2-3
charging times 2-4
general information 2-3
removal/replacement 2-5
running time 2-3
battery option 001
5-13
charge time 5-13
chemistry 5-13
operational characteristics 5-13
service life 5-13
typical operating time 5-13
weight 5-13
battery self-test
2-70
"Baud Rate" key description
3-22
bit map display self-test
2-72
"Bitmap Displays" key description
3-30
block data not allowed, error message
4-6
bus, GP-IB
language selection 2-58
setting of address 2-53
C
cabinet installation 1-19
cables
xi
"Cal Fac" key description
3-14
"Cal" key description
3-34
calibrate
2-8
Agilent 8480 series sensors 2-9
Agilent E-series sensors 2-8
using TTL inputs 2-12
calibration data
2-15
calibration factors
2-15
calibration table
2-19
editing 2-21
selection of 2-19
"Calibrator" key description
3-30
calibrator self-test
2-71
calling Agilent Technologies,
2-74
"Cancel" key description
3-20
carry case
2-3
carry handle, adjusting
1-18
caution
v
"Change" key description
3-24, 3-25
HP4402.book Page 1 Wednesday, November 29, 2000 4:46 PM