User`s guide

Contents-2 Agilent E4418B User’s Guide
The Rear Panel at a Glance.......................................................... 1-16
Adjusting the Carrying Handle.................................................... 1-18
Rack Mounting the Power Meter................................................. 1-19
Power Meter Operation..................................................................... 2-1
Introduction................................................................................... 2-2
Battery Operation (Option 001)................................................... 2-3
General Information............................................................... 2-3
Running Time......................................................................... 2-3
Charging Times ...................................................................... 2-4
Backlight................................................................................. 2-4
Battery Removal/Replacement .............................................. 2-5
Zeroing and Calibrating the Power Meter................................... 2-7
Zeroing the Power Meter........................................................ 2-7
Zero/Cal Lockout..................................................................... 2-7
Calibrating the Power Meter................................................. 2-8
Calibration Procedure Using Agilent E-Series
Power Sensors......................................................................... 2-8
Calibration Procedure using Agilent 8480 Series
Power Sensors......................................................................... 2-9
Zeroing and Calibrating Using TTL Inputs.......................... 2-12
Making Measurements with the Agilent E-Series
Power Sensors............................................................................... 2-15
Procedure................................................................................ 2-15
Making Measurements with the Agilent 8480 Series
Power Sensors............................................................................... 2-17
Procedure................................................................................ 2-17
Making Measurements using Sensor Calibration Tables .......... 2-19
Selecting a Sensor Calibration Table.................................... 2-19
Making the Measurement...................................................... 2-20
Editing Sensor Calibration Tables........................................ 2-21
Making Measurements using Frequency Dependent
Offset Tables ................................................................................. 2-27
Selecting a Frequency Dependent Offset Table.................... 2-27
Making the Measurement...................................................... 2-28
Editing Frequency Dependent Offset Tables........................ 2-29
Setting the Units of Measurement............................................... 2-32
Selecting Units of Measurement from the Softkeys ................... 2-33
Making Relative Measurements.................................................. 2-34
Procedure................................................................................ 2-34
Setting the Resolution.................................................................. 2-35
Setting Offsets............................................................................... 2-36
Setting Channel Offsets......................................................... 2-36
HP4402.book Page 2 Wednesday, November 29, 2000 4:46 PM