Technical data

3-2

8510XF Service Quick Reference Guide

Making 8510XF Adjustments

Table 3-2 Equipment required for 8510XF adjustments

Equipment Recommended Model Substitute

CRT demagnetizer or bulk tape

eraser

1. These adjustments apply to a CRT based display only.

Radio Shack Model 44-233 Techno Tool (USA) or

Nietronix (Europe) 692PR022

1 to 2 amp pencil sharpening motor (base held

near CRT with motor on), or electric drill

Flat-head screwdriver (small) At least 2 inches long, non-conductive none

10 dB pad 8493C 8360 series source with built-in attenuator

85102A/B and test set adjust software Part Number 08510-10024 Rev. A.01.10

Power Meter 437B power meter 438A or EPM-441A power meter

Power Sensors:

50 GHz

V band

W band

8481A or 8482A

8487A power sensor

V8486A power sensor

W8486A power sensor

N/A

Only available as a special

N/A

Adapter, 2.4 to 1.0 mm (f-f) 85059A K01

Adapter, V-band to 1.0 mm (f-f) V281C

Adapter, W-band to 1.0 mm (f-f) W281C

Laptop, personal computer or

controller

2, 3

2. Minimum 4 megabytes of available memory after BASIC has been loaded.

3. With BASIC for Windows and PCMCIA-GPIB card.

9000 series 200 or larger

8510XF port power level calibration

check software

08510-100xx

BASIC 6.3 or higher

4. Includes language extensions and drivers.

E2060B

Agilent VEE 4.0 Installation E2120-13605