Technical data

85108L System Manual
System Installation
System Arrival
2-15
Initial Trace
Once the system is turned on, you should see a trace similar to Figure 2-8 on the network analyzer
display. If your display is not similar, load the 85108 system configuration disk using the procedure
in Appendix C, “Loading the System Configuration Disk.”
If your display is similar to the trace as shown in Figure 2-8, continue with the operator’s tests in
Chapter 3, “Operation.”
Figure 2-8 85108 Initial Trace
Table 2-3 85108 System GPIB Addresses
Instrument GPIB Addresses
8510 network analyzer 16
System bus 17
Source #1 (RF) 19
Source #2 (LO) 18
Test set: 85110 20
RF switch 31