Technical data

85108L System Manual
System Installation
System Arrival
2-11
Refer to Figure 2-5.
8. Remove the pallet shipping block ② from the rear of the pallet. Remove the two bolts ①, one on
each corner, and pull the block ② out from under the rack.
9. Position the ramp so that the block of wood under the ramp loads into the edge of the pallet with
the strip of wood forming a lip. This holds the ramp in place while the rack is moved across the
pallet and down the ramp.
10. Raise the rack leveling feet to their highest position.
CAUTION Make sure that the leveling feet on the ramp are raised before you roll the rack down
the ramp. If the leveling feet are not raised, they can catch on the ramp and cause the
rack to tip over.
11.Carefully roll the rack ③ down the ramp.
Figure 2-5 Unpacking - Illustration 4