Technical data

85108L System Manual
System and Documentation Overview
Manual Overview
1-4
System Overview
The pulsed-RF network analyzer system allows you to measure and display the relative magnitude
and phase shift of the component under test as a function of time with an equivalent bandwidth of
1.5 MHz. You can evaluate dynamic pulsed-RF characteristics for pulse widths down to 1
microsecond.
You can also configure a pulsed-RF system using your existing 8510 network analyzer system by
adding pulsed-RF capability (Option 008) to your 8510C network analyzer. (Refer to “Upgrade
Paths.”)
Systems Covered by This Manual
The serial number of your system is printed on a label located in the lower left corner on the front of
the system cabinet. The serial number prefix is the first four digits followed by a letter. The contents
of this manual apply directly to systems having the same serial number prefix, or higher, as listed
on the title page of this manual under the heading “Serial Numbers.”
85108 Pulsed-RF System Options
The following options are available with the 85108 system:
• Option 001. This test set option adds IF switching capability to allow a total of four test sets to
be connected to the 8510 at the same time. The test set in use is selected from the 8510 front
panel. The 20 MHz IF signal is transmitted from the selected test set through the Option 001
test set(s) to the network analyzer. IF switching is performed automatically by the Option 001
test set(s), without reconnections. For more information, refer to “Controlling Multiple Test Sets”
on page 3-5.
• Option 010. This option adds time domain capability to the 8510 network analyzer.
Upgrade Paths
To add pulsed-RF capability to an 8510C network analyzer, order an 85111B upgrade kit.
Operating Precautions
CAUTION Handle only at static-safe workstations. Beware of damage from electrostatic
discharge (ESD). The input connections on the test set (test ports or cables or
adapters connected to the test ports) are very sensitive to ESD. Use a grounded wrist
strap when attaching devices to the input connectors.
CAUTION During the retrace time of the network analyzer, the source power may remain on.