Technical data

3-2 8510C Service Quick Reference Guide
8510C Adjustments
Most of the 8510C is self adjusting. Table 3-1 lists the adjustments most frequently needed
for 8510C system service.
Table 3-1 Typically Used 8510C Adjustments
Title Adjustment Function Assembly Adjusted
Vertical Alignment Adjustment
a
(for CRT display only)
a. The original 85101C display/processor incorporated a cathode ray tube (CRT). The current design
incorporates a liquid crystal display (LCD). This adjustment is for an 85101C equipped with a CRT
display. For information on determining the type of display, refer to the NOTE on page 2-9.
Aligns softkey labels and mechanical
softkey buttons
A11
Degaussing the Display
a
(for CRT display only)
Demagnetizes the display A11
8350B Plug-ins front panel FREQ
CAL
RF frequency calibration 8350B plug-in
8360 Series Sources Full User Cal Full user calibration 836XX Series Sources
Trim Sweep Compensates for component tolerances
in staircase generator
A20
Table 3-2 Required Test Equipment for 8510C System Adjustments
Equipment Recommended Model Substitute
CRT demagnitizer or bulk tape
eraser
Radio shack Model 44-233
Techni-Tool (in USA) or
Nietronix (in Europe) 692PR022
1 to 2 amp pencil sharpener motor
base held near CRT with motor on,
or electric drill.
Flat-head screwdriver At lease 2-inches long,
non-conductive
none
10 dB pad 8493C 8360 Series source with built-in
attenuator
85102 service adjustment disk 08510-10024 Rev. A.01.10
Mat Kit ASTAT 85034-80013
Work Surface 46298S for 85043C cabinet
Work Surface (Large for XF) 85106-60038 for 85043C cabinet
5-1/4 in drawer 46298S for 85043C cabinet
Screws/nut holder E7797A for 85043C cabinet