User`s guide

Command Description

Setup source parameters

[PRESET] Reset source to a known state

POWER [POWER LEVEL] 5 dBm Set test port power to +5 dBm (

0 max

path loss

)

Create frequency list

FREQUENCY[MENU] Access the frequency softkey menu

[more] Display next softkey menu

[Fltness Menu] Access the frequency list softkey menu

Enter List [Freq] 5 GHz Enter 5 GHz as the first frequency

Entering a frequency automatically sets the offset and dwell to 0 dB and 10 ms, respectively

Enter 18, 13, 11, and 20 GHz from the keypad

Access user flatness correction menu

POWER [MENU] Access power softkey menu

[more] Display next softkey menu

[Fltness Menu] Access flatness softkey menu

Clear flatness array

[Delete Menu] Access delete array softkey menu

Delete [All] Clear array

MENU SELECT [PRIOR] Leave delete menu

Display previous softkey menu

[more] Display next softkey menu

[Copy List] Copy the frequency list into the correction table in a sequential order

[Freq Follow] Set source to the active correction frequency in the flatness array

(i.e when the arrow points to the 5 GHz correction data point in the

correction table, the source is also set to a CW frequency of 5 GHz)

[more] Display next softkey menu

Calibrate the power meter to the power sensor in use

Connect power meter sensor to test port

Enter the cal factor for first correction frequency (5 GHz)

Enter correction data into table

POWER [FLTNESS ON/OFF] Enable User Flatness Correction; power meter will display

corrected data

Enter [Corr] Enter correction data - rotate knob until power meter displays

desired power level (5 dBm)

Allow entry of next frequency correction

Enter in the power meter the sensor's cal factor for the next frequency in the array

Repeat until each correction has been entered

[SAVE]n Save the source parameters including the correction table in an

internal register

Remove power meter sensor from test port and reconnect device

Activate List Mode

SWEEP [MENU] Access sweep softkey menu

Sweep Mode [List] Select frequency list mode

➮