User`s guide

8 82357B User’s Guide
1 Installing the Agilent 82357B
4 Observe the LEDs on the 82357B for at least 10 seconds.
See Chapter 2, “Using the Agilent 82357B” for a
description of the normal LED sequence during an initial
installation of the 82357B.
a Initially, only the red FAIL LED should be ON. After a
few seconds, all three LEDs should be ON. When all
three LEDs are ON, this shows that the 82357B has
been successfully installed.
b If all three LEDs are not ON after 10 seconds and all
Windows Plug- and- Play Manager activity has ceased,
STOP. See Chapter 3, “Troubleshooting the Agilent
82357B” for diagnostics information.
NOTE
For Windows Vista, Windows 7, and Windows 8, there will be no Windows
Plug and Play Manager Sequence because once 82357B is initially
plugged into a USB port it will automatically install the driver.