User`s guide

2-9
Using the Agilent 83433A
Connecting the Agilent 83433A to a Bit-Error-Ratio Test Set
Connecting the Agilent 83433A to a
Bit-Error-Ratio Test Set
The following procedure describes how to connect the lightwave transmitter
to a bit-error-ratio test set (BERT). The following equipment is used:
• Agilent 83433A lightwave transmitter
• Lightwave receiver or Agilent 83434A
• Bit error ratio tester or Agilent 71612B error performance analyzer
• Optical attenuator
1
Connect the equipment as shown in Figure 2-2.