Specifications

94
Chapter 3: Testing Performance
To test the multi-card module
To test the multi-card module
This section applies when cards were received as a multi-card module, and you
have reconfigured them as single card modules for testing.
All single card modules must be reconfigured into their original multicard module
configuration upon completion of the “16760A Minimum Data Eye Width and
Minimum Clock Interval Performance Test Procedure”.
Turn off the mainframe and follow the procedures in “Preparing for Use,”
beginning on page 15 to return the cards to their original configuration.
Then run the self-tests as described in “Do a self-test on the logic analysis
system.” on page 40.
Finally, complete the “Performance Test Record” on page 95.
The Performance Test Record is designed to be used with the equipment
specified on page 39. If you are not using the recommended test equipment, you
will need to create your own version of the Performance Test Record with
parameters that are specific to your test equipment.