Specifications

74
Chapter 3: Testing Performance
Test Pod 1 in the 800 Mb/s mode
mode.
11 In the “Setup and Trigger...” window, Sampling tab, Clock Setup area, set
the clock mode to “Rising Edge”.
12 In the logic analyzer’s Setup and Trigger window, Format tab, unassign all
pod 2 bits.
13 Assign bits 2, 6, 10, and 14 of Pod 1.
14 Ensure that the Pod 1 threshold is set to 1 volt. See page 53.
15 In the “Setup and Trigger...” window, Format tab, ensure that the J clock
threshold is still set to Differential.
16 Re-establish the trigger function:
a In the logic analyzer’s Setup and Trigger window, select the Trigger tab,
and the Trigger Functions subtab.
b Select “Find pattern” and select the “Replace” button.
c Enter “A” in the “Label 1 = “ field.
Determine and set Eye Finder Position (800 Mb/s mode)
17 In the Eye Finder (Sampling Positions) window, expand “Label1 (4
channels)”.
18 Grab the blue bar for “Label1 (4 Channels)” and move it to approximately
-2.1 ns. All blue bars will follow.
19 Run Eye Finder and note the average sampling position chosen by Eye
Finder:______ns. In the following example, the average sampling position
is -2.09 ns. Note that in this step, you place the blue bars in the first
narrow window (not the wide window) that appears to the left of zero in
the Eye Finder display. Then run Eye Finder. The position may be