Specifications

Chapter 3: Testing Performance

Test Pod 1 in 200 Mb/s mode

b Select OK to close the error message window.

c In the Marker Setup window, select the G1 Define... button. The

“Marker Pattern for <G1>” window will appear. In the pattern field,

enter "a", then select Close.

d In the Marker Setup window, select the G2 Define... button. The G2

Marker Pattern window will appear. In the pattern field, enter "5", then

select Close.

e In the Marker Setup window, select the 'occurs' value field that

corresponds to marker G1. Enter 65535.

f In the Marker Setup window, select the 'occurs' value field that

corresponds to marker G2. Enter 65535, then press Enter.

g Select Close.

2 In the Listing window, Select the Run Repetitive icon. The analyzer will

run and the listing window will update every few seconds.

Determine PASS/FAIL (2 of 2 tests)

Pass/Fail Point: The Listing window is set up to search for the appropriate

number of A's and 5's in the acquisition. If the logic analyzer does not

detect the correct number of A’s and 5’s, an error window will appear. The

window will be named 'Error - Listing', and it will say “Pattern NOT found