Specifications

6
Contents
Configure the logic analysis system 51
Adjust sampling positions using Eye Finder 56
Re-aligning a stray channel 57
Test Pod 1 in 200 Mb/s mode 59
Determine PASS/FAIL (1 of 2 tests) 59
Open and configure the Listing window. 59
Determine PASS/FAIL (2 of 2 tests) 61
Test the complement of the bits (200 Mb/s mode) 63
Test Pod 2 in 200 Mb/s mode 65
Test the complement of the bits (Pod 2, 200 Mb/s mode) 66
Test Pod 1 in the 400 Mb/s mode 67
Determine and set Eye Finder Position (400 Mb/s mode) 68
Test the complement of the bits (Pod 1, 400 Mb/s mode) 70
Test Pod 2 in 400 Mb/s mode 71
Test the complement of the bits (Pod 2, 400 Mb/s mode) 72
Test Pod 1 in the 800 Mb/s mode 73
Adjust the measured pulse width to 750 ps 73
Determine and set Eye Finder Position (800 Mb/s mode) 75
Test the complement of the bits (Pod 1, 800 Mb/s mode) 77
Test Pod 2 in 800 Mb/s mode 79
Test the complement of the bits (Pod 2, 800 Mb/s mode) 80
Test Pod 1 in the 1250 Mb/s mode 81
Determine and set Eye Finder Position (1250 Mb/s mode) 82
Test the complement of the bits (Pod 1, 1250 Mb/s mode) 84
Test Pod 2 in 1250 Mb/s mode 85
Test the complement of the bits (Pod 2, 1250 Mb/s mode) 86
Test Pod 1 in the 1500 Mb/s mode 87
Adjust the measured pulse width to 600 ps 88
Determine and set Eye Finder Position (1500 Mb/s mode) 90
Test the complement of the bits (Pod 1, 1500 Mb/s mode) 91
Test Pod 2 in 1500 Mb/s mode 93
Test the complement of the bits (Pod 2, 1500 Mb/s mode) 94
To test the multi-card module 95