Specifications

Chapter 3: Testing Performance

Test Pod 1 in 200 Mb/s mode

The steps that follow include pass/fail criteria.

Determine PASS/FAIL (1 of 2 tests)

1 PASS/FAIL: If an eye exists near the recommended starting position for

every bit, and Eye Finder places a blue bar in the eye for each bit, then the

logic analyzer passes this portion of the test.

2 If an eye does not exist near the recommended starting position for every

bit or Eye Finder cannot place the blue bar in the eye, then the logic

analyzer fails the test. Record the failure in the test record (shown on page

95).

Open and configure the Listing window.

a In the Setup and Trigger window, select Window from the menu bar,

then select Slot n: Analyzer<n> (where n is the slot where the module

under test is installed). At the pop-up menu, select Listing. The Listing

window will appear.