Specifications

22
Chapter 2: Preparing for Use
5 Begin stacking the cards together according to the drawing under step 1.
While stacking, connect the free end of the 2x40 cable on the lower card
J9 to J500 of the upper card, on the underside of the card. Connect the
free end of the 2x40 cable on the lower card J10 to J501 of the upper card,
on the underside of the card.
NOTE: These instructions show a five-card set. If you are planning a set of less than five cards,
see the diagram on page 20 for correct placement.
CAUTION: When stacking cards, make sure that the cards do not rub together and damage
components on the underside of the cards.