Specifications

132
Chapter 6: Replacing Assemblies
b Install the two shorter screws (H4) through the rear of both cable
clamps into the rear panel. Do not tighten the screws yet.
c Tighten the short rear panel cable clamp screws (H4) to 5 in/lb. Then
tighten the longer cable clamp screws (H5) to 5 in/lb.
CAUTION: If you over tighten the screws, the threaded inserts on the rear panel, the threaded
inserts on the circuit board, or the cable clamp itself might break. Tighten the screws only
enough to hold the cable in place, approximately 5 in/lb.