Specifications

121
Chapter 5: Troubleshooting
To test the cables using an Agilent E5379A Differential
Probe
This test allows you to functionally verify the logic analyzer cable and an Agilent
E5379A probe.
Equipment Required
1 Connect the logic analyzer to the stimulus board.
a Connect an Agilent E5379A 100-pin differential probe to the logic
analyzer cable to be tested.
b Connect the probe input to the stimulus board connector Pod 1.
c Connect a power cord to the stimulus board power supply. Connect the
stimulus board power supply output to the stimulus board power
supply connector J82.
d Plug in the stimulus power supply into line power. The green LED DS1
should illuminate showing that the stimulus board is active.
Equipment Critical Specification Recommended Part
Stimulus Board No Substitute 16760-60001