Specifications

6
Contents
Test Pod 1 in 250 Mb/s Mode 47
Determine PASS/FAIL (1 of 2 tests) 47
Close the Eye Finder and Analyzer Setup Windows 47
Configure the markers 47
Determine PASS/FAIL (2 of 2 tests) 49
Test the complement of the bits (250 Mb/s mode) 50
Test Pod 2 in 250 Mb/s Mode 52
Test the complement of the bits (Pod 2, 250 Mb/s mode) 53
Test the Remaining Pods in 250 Mb/s Mode 54
Test Pod 1 in 500 Mb/s Mode 54
Determine and set Eye Finder Position (500 Mb/s mode) 55
Test the complement of the bits (Pod 1, 500 Mb/s mode) 57
Test Pod 2 in 500 Mb/s Mode 57
Test the complement of the bits (Pod 2, 500 Mb/s mode) 58
Test Pods 3 and 4 in 500 Mb/s Mode (16910A only) 59
Conclude the State Mode Tests 59
Performance Test Record 60
4 Calibrating
Calibration Strategy 62
5 Troubleshooting
To use the flowcharts 64
To run the self tests 67
Self-Test Descriptions 67
To exit the test system 70
To Assemble the 2 x 9 Test Connectors 71
To test the cables 73
Set up the test equipment 73
Connect the test equipment 74
Configure the logic analyzer to test Pod 1 74
Adjust sampling positions using Eye Finder 78
Connect and configure the logic analyzer to test other pods 80