Technical data

SYSTem Commands SCPI Commands Reference
Agilent 81133A/81134A Pulse Generator Programming Guide, March 2007 83
:SYSTem:COMMunicate:LAN[:SELF]:DHCP
Syntax :SYST:COMM:LAN[:SELF]:DHCP
Form Set
Description Enables/disables the DHCP.
•DHCP enabled
If DHCP is enabled, the instrument will request its own LAN
settings from the network. You only need to specify the LAN
name with
“:SYSTEM:COMMunicate:LAN[:SELF]:NAME” on
page 83.
•DHCP disabled
If DHCP is disabled, you have to set the instrument IP address,
subnet mask, gateway and host address with:
– “:SYSTem:COMMunicate:LAN[:SELF] :ADDRess” on page 84
– “:SYSTem:COMMunicate:LAN[:SELF] :SMASk” on page 84
– “:SYSTem:COMMunicate:LAN[:SELF] :DGATeway” on page 85
Parameter 1|0|ON|OFF
*RST value –
Example Disable DHCP:
:SYST:COMM:LAN[:SELF]:DHCP OFF
:SYSTEM:COMMunicate:LAN[:SELF]:NAME
Syntax :SYST:COMM:LAN[:SELF]:NAME <LAN name>
Form Set
Description Sets the LAN name. This command is only necessary for DHCP.
Parameter alphanumeric
*RST value –
Example :SYST:COMM:LAN:NAME PP81134A01