Technical data

Status Handling Commands SCPI Commands Reference
Agilent 81133A/81134A Pulse Generator Programming Guide, March 2007 77
When a parameter range change occurs, the corresponding bit in
the QUEStionable:MONotony status event register is set to indicate
that the output signal may not vary monotonically with the
programmed parameter value.
The following commands are used to access the registers within
the status group.
:STATus:QUEStionable:MONotony[:EVENt]?
Syntax :STAT:QUES:MON[:EVEN]?
Form Query
Description This command reads the event register in the
QUEStionable:MONotony status group.
Parameter –
*RST value –
:STATus:QUEStionable:MONotony:CONDition?
Syntax :STAT:QUES:MON:COND?
Form Query
Description This command reads the condition register in the
QUEStionable:MONotony status group.
NOTE The Agilent 81133A/81134A Pulse Generator does not use the
condition register of the QUEStionable:MONotony status group,
therefore, this command is redundant.
Parameter –
*RST value –