Technical data

SCPI Commands Reference DIGital Commands
30 Agilent 81133A/81134A Pulse Generator Programming Guide, March 2007
• The complete pattern is stored temporarily in the instrument. If
there are no restrictions to the maximum pattern length
regarding frequency and frequency divider, the complete pattern
will always be continually emitted. If there are restrictions to
the maximum pattern length, the stored pattern will be emitted
up to the maximum pattern length and then repeated from the
beginning.
• The channel mode must be data mode.
• The main mode of the instrument must be Pulse/Pattern. Burst
and RBurst mode are not allowed.
• The extended pattern is lost by any of the following actions:
– Modifying the pattern in the pattern editor of the user
interface
– Sending another pattern by :DIG:PATT:DATA or
:DIG:PATT:LDAT
– Changing channel mode or main mode of the instrument
– Recalling a setting or resetting the instrument
– Restarting the instrument
In all these cases, the pattern length is set to the actual data
length.
*RST value –
Example The above example would be sent as:
:DIG:PATT:LDAT #532768AB03CDAD......