Technical data

Common Commands SCPI Commands Reference
Agilent 81133A/81134A Pulse Generator Programming Guide, March 2007 19
Common Commands
The following table shows the IEEE 488.2 Common Commands
available with the Agilent 81133A/81134A Pulse Generator.
Command Parameter Description
*CLS - Clears the status register
*ESE <0–255> Sets the event status register mask
*ESR? - Reads the event status register
*IDN? - Reads the instrument's identification string
*LRN? - Reads a complete instrument setting
*OPC - Sets the operation complete bit when all pending
actions are complete
*OPT? - Reads the installed options
*RCL <1–9> Reads a complete instrument setting from memory
*RCL <0> Reads the standard settings from the memory.
For a list of standard settings, see “Standard
Settings” on page 21.
*RST - Resets the instrument to standard settings.
For a list of standard settings, see “Standard
Settings” on page 21.
*SAV <1–9> Saves the complete instrument setting to the
memory
*SRE <0–255> Sets the service request enable mask
*STB? - Reads the status byte
*TST? - Executes the instrument's self-test
*WAI - Waits until all pending actions are complete