Specifications
Table Of Contents
- General Information
- Preparing for Use
- To inspect package contents
- To connect power
- To connect the mouse, keyboard, LAN, printer, and GPIB cable
- To connect the standard 10073C probes
- To connect optional InfiniiMax oscilloscope probes
- To connect the digital probe
- Digital probe lead set
- To tilt the oscilloscope upward for easier viewing
- To turn on the oscilloscope
- To turn off the oscilloscope
- To verify basic oscilloscope operation
- Installing application programs on Infiniium
- Changing Windows System Settings
- To clean the oscilloscope
- Testing Performance
- Calibrating and Adjusting
- Troubleshooting
- To install the fan safety shield
- To troubleshoot the oscilloscope
- Primary Trouble Isolation
- No Display Trouble Isolation
- To check the backlight inverter voltages
- To check the display board video signals
- Power Supply Trouble Isolation
- To check probe power outputs
- To Check the keyboard
- To check the LEDs
- To check the motherboard, CPU, and RAM
- To setup the BIOS
- To troubleshoot the acquisition system
- Software Revisions
- Replacing Assemblies
- To return the oscilloscope to Agilent Technologies for service
- To remove and replace the top cover
- To remove and replace the bottom sleeve
- To disconnect and connect Mylar flex cables
- To remove and replace the CD-ROM drive
- To remove and replace the AutoProbe assembly
- To remove and replace the internal digital input cable (MSO models only)
- To remove and replace the backlight inverter board
- To remove and replace the front panel assembly
- To remove and replace the keyboard, touch screen, and flat-panel display assemblies
- To remove and replace the acquisition board assembly
- To remove and replace the PCI bridge board
- To remove and replace the display board
- To remove and replace the hard disk drive
- To remove and replace the motherboard
- To replace the Intel motherboard with the ADLINK motherboard
- To remove and replace the power supply
- To remove and replace the fan controller board
- To remove and replace a fan
- To remove and replace the probe power and control assembly
- Replaceable Parts
- Theory of Operation
- Index
Chapter 1: General Information
Specifications & characteristics
16
Specifications & characteristics
For complete specifications and characteristics, direct your web browser to www.agilent.com
and perform a search for the oscilloscope’s model number. Then select “Data Sheets” from the
Library.
Specifications that are pertinent to each test are given in the "Testing Performance" chapter.
Specifications are valid after a 30 minute warm-up period, and within
± 5°C from the temperature
at which the last self-calibration was performed.
N5402A CAN Serial Data Analysis Software
N5415A InfiniiScan Event Identification Software
E2690B Oscilloscope Tools for Advanced Jitter Analysis
N5397A FPGA Dynamic Probe for Infiniium Mixed-Signal Oscilloscopes
N5392A Ethernet Electrical Performance Validation and Compliance Software
N5395B Ethernet Electrical Compliance Test Fixture
N5396A Gigabit Ethernet Jitter Test Cable
N5416A USB 2.0 Electrical Performance Validation and Compliance Software
E2646A USB 2.0 SQiDD Test Fixture
N2649A USB 2.0 High-Speed Test Fixture Set
E2625A Communication Mask Test Kit
E2682A Voice Control for Hands-Free Operation