Programming instructions

6
a Select Output On to enable the output of the unit. Select Output Off to
turn the output off. Note that the selected waveshape will not appear on the
Main window unless you click the Measure button.
To view output measurements,
a Select the Config Measurements command in the Measure menu. Select
the Configure Waveform Display folder.
a To view voltage or current measurements, select Voltage, Current, or
Voltage + Current in the Waveform to Display dropdown list.
a To view harmonic measurements, select a harmonic display functions.
a Click the Measure button to make an output measurement. The following
figure shows a sample voltage harmonics measurement. Note that for 3-
phase ac sources, you can only measure one phase at a time. Only the
measurement of the selected phase is returned.
Click
To save the configuration settings,
a Click File, Save Config in the menu.
a Enter a filename (setup files have an .set extension) and click Save.
Note that Output Control settings are NOT saved in the setup file.
Specify type of
measurement.
Only applies to
units with the AUX
channel option.
Select units for
h
a
rm
o
ni
c
g
r
ap
h
a
x
es
Displays the
specified
harmonics.