Programming instructions

3
Description
What the
GUI Will
Do
The Agilent AC Source Graphical User Interface (GUI) is an easy
to use soft front panel for the Agilent Technologies 6800-series
AC Power Source/Analyzers. With it, you can:
a Control output and measurement functions from a single
screen.
a View an oscilloscope-like display of actual output
waveforms.
a View the harmonic content of the output waveform.
a Easily generate complex output transients and user-defined
waveforms by clicking and dragging the mouse.
a View the instrument commands generated by the graphical
user interface.
a Operate in either simulation mode (no ac source hardware
required), or in instrument control mode.
What the
GUI Will
Not Do
The Graphical User Interface does not:
a Automatically generate test programs
a Control instruments other than Agilent ac sources
a Provide drivers for other GPIB instruments
a Link with the Agilent HFTS software
a Operate with Windows 3.1
System Requirements
PC and
Memory
a Agilent AC Source GUI will run using the same miniumum PC
and memory as required by the following operating systems.
32-bit
Platforms
a Windows 95 - 98, 2000
a Windows NT 4.0
Supported
I/O
a Agilent 82350A, 82340B, 82341C, 82341D, 82335B
1
a National AT GPIB/TNT, AT GPIB/TNT PnP (Windows 95)
a
1
The Agilent 82335B is only supported for Windows 95, provided you have
either the E2094F or E2094E I/O library.
Supported
Ac Source
Models
a Agilent 6811A/B, 6812A/B, 6813A/B, 6814B, 6834B
a Agilent 6841A, 6842A, 6843A (in Normal mode only)
Not recommended for use with RS-232 interface