User`s guide

M3000A/M3046A/M3015A/M3016A Service Guide
2-22 Installing the Instrument
Site Preparation Guidelines
Although the Instrument (Monitor and Measurement Server or, where present, Measurement
Server Extension) is primarily a portable Monitor, some site preparation must be done before
using it in certain locations. Additionally, good operating practices are also recommended.
• Check that the operating environment is reasonably free from dust, vibration, corrosive or
explosive gases and is within specified temperature and humidity ranges.
• Position the Instrument so that the display is clearly visible and the controls are easy to
reach.
• The M3046A 0867 be grounded during operation. If a three-wire receptacle is not availa-
ble then a hospital electrician must be consulted to ensure that proper grounding is available
on installation. 1(9(5 attempt to use a three-wire to a two-wire adapter with the
M3046A. The Instrument must be grounded whenever it is connected to the mains power
using a 3-pin plug.
Installing the Table Mount (M3080A #A10)
The Table Mount is intended for any flat, level surface. To mount the plate securely, you need
4 screws. These are not provided because the type of surface dictates the type of screw.
6WHS Unpack the Table Mount and check all parts are available.
6WHS Select 4 screws (appropriate to surface material).
6WHS Insert the 4 screws through the screw holes provided in the plate.
6WHS Tighten the screws.
The Monitor snap-fits onto the plate. To release the Monitor, press the button on the front of
the plate.