User`s guide

M3000A/M3046A/M3015A/M3016A Service Guide
2-20 Installing the Instrument
Installing the Wireless Infrared Printer Connector (M3080A #H02)
If the Monitor is to be used within the SDWLHQWYLFLQLW\ when it is connected to a printer, the
connection must only be made using the JetEye Printer wireless infrared connector. To use
this, you need a Centronics printer extension cable.
The JetEye Printer wireless infrared connector provides an infrared printer connection from
the infrared-equipped Monitor to a parallel printer by attaching to the standard parallel printer
connector and providing both a parallel and an infrared interface.
To find out how to install the JetEye Printer wireless infrared connector software, refer to the
accompanying documentation. Install the device support tray (supplied with kit) and
connector as follows:
6WHS Attach the support tray to the front, right corner of the table mount. The plastic sup-
port tray push-fits over the lip of the table mount. Make sure the dove-tail slot on
the tray engages with the table mount correctly.
6WHS Remove the adhesive protection strip from the support tray.
6WHS Press the JetEye sensor firmly onto the adhesive strip. (It may be helpful to place
the Monitor in position to line-up the infrared devices.
Printer
Power
6 m
Infrared Access Point
Table
Support Tray
Mount