User`s guide

M3000A/M3046A/M3015A/M3016A Service Guide
2-18 Installing the Instrument
Connecting a Printer
6HOHFWLQJD3ULQWHU
If you are printing locally, you can use either of the following accessories:
• a DeskJet 400/420, with an infrared-to-parallel converter (JetEye
R
Printer wireless infrared
connector), which you can order as M3080A Option #H05, or
• a LaserJet 6P or 6MP with a built-in infrared interface.
You can also use the LaserJet with the JetEye, but then you will also need a Centronics
printer extension cable. (Installing the wireless infrared printer connector is covered in the
next section of this chapter.)
Make sure that the infrared printer port is at least 50cm (20 inches) from any SpO
2
transducer
while you are printing, to avoid disturbing the SpO
2
measurement.
If you have an M3 Print Server, you can, in addition, use one of the following network
printers:
• an HP LaserJet 4000N, or
• an HP DeskJet 1600CN.
Or you can use an HP LaserJet 6P or HPDeskJet 400L attached locally to the Print Server
PC.
6WHS Press the 6HWXS key.
6WHS Move the highlight to 3ULQWHU.
6WHS Press on the strip to select the Printer window.
6WHS Move the highlight to 3ULQWHU.
6WHS Press on the strip.
6WHS Select the appropriate setting according to the following table:
None If there is no printer. All printing operations are disabled.
Local To enable a local printer.
Remote
a
1
a. The remote printer option is only available when the Monitor is connected
to the M3 Print Server.
To enable a printer connected through the network.
b
Remote
a
2 To enable a printer connected through the network.
b
Remote
a
3 To enable a printer connected through the network.
b