User`s guide

M3000A/M3046A/M3015A/M3016A Service Guide
2-12 Installing the Instrument
Attaching the Measurement Server to a Mount
6WHS Make sure the Measurement Server is oriented correctly relative to the mount (see
the picture below).
6WHS Place the Measurement Server on the back mount.
If it is not tight against the mount, slip it in the direction of the measurement con-
nectors until it is.
6WHS Slip the Measurement Server forward until it clicks into place.
Detaching the Measurement Server from a Mount
6WHS Press and hold the latch (in the middle at the top of the mount) away from the Meas-
urement Server.
6WHS Slide the Measurement Server off the mount in the direction of the measurement
connectors.
Positioning the Measurement Server on a Clamp Mount
For convenience, if you have your Measurement Server on the clamp mount, you can
position it with any one of the four edges facing upwards (four positions). Reposition it by
completing the following steps:
Latch