User`s guide
M3000A/M3046A/M3015A/M3016A Service Guide
Installing the Instrument 2-9
Connecting the M3000A Measurement Server...
ZLWKWKH0$0HDVXUHPHQW6HUYHUGLUHFWO\RQWKH0RQLWRU
You can connect the Measurement Server to the Monitor by mounting it directly on the
Monitor:
6WHS Make sure that your Monitor has a link bar:
If your Monitor does not have a link bar,
a. Position the link bar as shown in the diagram above.
Make sure that the guide is in the slot under the plug (which connects to the Meas-
urement Server).
b. Press the Link Bar into position until it clicks.
c. Turn the latch guard to lie perpendicular across the edge of the latch.
6WHS Place the Measurement Server on the back of the Monitor.
If it is not tight against the back of the Monitor, slip it away from the link bar until it
is.
6WHS Slip the Measurement Server forward until it clicks into place.
Link Bar
Plug to
Measurement Server
Latch