User`s guide

M3000A/M3046AM3015A/M3016A Service Guide
1-26 Introduction to the Instrument
Non-invasive Blood Pressure (NBP) Measurement
'HVFULSWLRQ
The Measurement Server has a non-invasive blood pressure measurement for the Monitor
monitoring device. It is designed to be used with adult, paediatric, or neonatal patients, in
ICU and OR environments.
0HDVXUHPHQWV
The measurement produces numerics for the systolic, diastolic, and mean blood pressure
values.No wave is associated with this measurement.
Three different methods can be used to obtain the measurements, as follows:
• 0DQXDO²For each request, one measurement of systolic, diastolic, and mean pressures is
taken.
• $XWR²Repeated measurements of the three values are taken at timed intervals specified by
the user.
• 6WDW²Measurements of the three values are taken immediately and repeatedly over a
period of five minutes. This method uses a faster measurement procedure but produces a
less accurate reading.
1%3)HDWXUHV
This illustration shows the user controls and connector for the measurements. The parts are
described in the paragraphs following the illustration.
6WDUW6WRS6WDW.H\
A standard NBP connector
A single-press key, used to start
or stop a manual measurement,
or start an automatic measurement cycle.
connects to the cuff.