User`s guide

i
AC Power
connector, 1-4
LED, 1-4
Accuracy and Calibration Procedures, 4-19
Accuracy and Performance Procedures, 4-19
adjustments, v
alarm
limit, 1-8
message, 1-8
analog ECG signal, 2-5
anesthetics
operation in presence of flammable, 2-4
Arterial Oxygen Saturation and Plethysmography (SpO2/PLETH) Module
Block Diagram, 1-31, 1-35
Description, 1-30, 1-34
Features, 1-30
PLETH Waveform, 1-30
Safety, 1-30
Measurements, 1-30, 1-34
Theory of Operation, 1-31, 1-35
assembly, v
Backlight Test, 5-35
Backlight Tube Assembly, 3-5
BAD SERVER LINK
INOP description, 5-13
Barometric Pressure Check and Calibration, 4-13
Battery
charging, 3-13
battery
compartment, 1-4
LED, 1-4
Battery Handling, 3-10
Battery handling, 3-10
Battery Level Low message, 5-38
BATTERY LOW
INOP description, 5-13
BATTERY MALFUNCT.
INOP description, 5-13
Battery Status
checking, 3-10
window, 3-14
brain examination, 2-3
cabinet grounding, 2-2
cabinet installation, 2-4
Cause of Failure, 5-17
CHARGER MALFUNCT
INOP description, 5-13
Check for Obvious Problems, 5-3
CHECK INPUT DEVICE
INOP description, 5-14
Check Status Log message, 5-38
Checks before opening the instrument, 5-3
Cleaning Agents, 3-9
Cleaning agents, 3-9
Cleaning of the System, 3-8
clearance, 2-4
CO2
Calibration Verification, 4-17
Flow Rate Check and Calibration, 4-15
Noise Check, 4-16
Pump check, 4-15
CO2 AUTOZERO
INOP description, 5-16