User`s guide
M3000A/M3046A/M3015A/M3016A Service Guide
6-12 Repairing the Instrument
5HILWWLQJWKH:LUHOHVV$VVHPEO\
To refit the wireless assembly, complete the steps for removing the wireless assembly in
reverse.
5HILWWLQJWKH&KDVVLV
To refit the chassis, complete the steps for removing the chassis in reverse. When
reconnecting the Antenna Cable, observe the following:
• Route the free end of the antenna cable through the middle hole (1, below) in the right-hand
column of three holes, as viewed from the back side of the sheet metal.
• Connect the free end of the antenna cable to the connector on the corner of the wireless
LAN board (2, above).
5HILWWLQJWKH%DWWHU\
To refit the battery, do the following:
6WHS Slide the battery compartment door toward the rear of the Monitor, and open it
down.
6WHS While holding the battery extractor tape up and out of the way, insert the battery
with the battery guide-groove facing up and the battery socket towards the inside of
the Monitor.
6WHS Push the battery all the way into the compartment making sure the socket is firmly
engaged (the battery can be pushed no further).
6WHS Close the battery compartment door.
1
2