User`s guide

M3000A/M3046A/M3015A/M3016A Service Guide
6-4 Repairing the Instrument
6WHS Push a thin-bladed screwdriver into the hole next to the cover.
6WHS Release the cover.
6WHS Prise open the clip on the Server-to-Monitor link bar and slide it off. On newer
monitors just turn the catch (holding the link bar) into the vertical position.
6WHS Lay the Monitor on its rear panel and pull out the two latches - there is one on each
side of the Monitor Bezel.
6WHS Stand the Monitor up again and gently lift the Monitor Bezel up and out. Gently let
it rest in front of the Monitor. Be careful. It still has a cable attached.