User`s guide

M3000A/M3046AM3015A/M3016A Service Guide
4-8 Testing the Instrument
7KH7HVW²Press the 6HWXS button, move the highlight to (&*, and press on the TouchStrip.
7KH5HVXOW²The ECG window should appear verifying that the System Board and
Measurement Server are communicating with each other.
6\VWHP6HOI7HVW
6WHS Make sure the Measurement Server is connected to the Monitor, and the Monitor is
switched on. (For SpO
2
, mainstream CO
2
, Pressure, or Temperature, an appropriate
transducer must be plugged into the Measurement Server – or, for mainstream CO
2
,
the Measurement Server Extension – in order to get a test reading. For sidestream
CO
, appropriate tubing must be plugged into the Measurement Server Extension in
order to get a test reading.)
6WHS Press the 6HWXS button.
6WHS Move the highlight to 7HVW6LJQDOV.
6WHS Press on the TouchStrip and observe the display. An example test looks similar to
the following illustration (the shape of the test signals depends on the selected filter
mode.
As well, the table on the following page lists Self-Test values.
.
7KH6HOI7HVWHQVXUHV
WKDWWKH,QVWUXPHQWLV
IXQFWLRQLQJFRUUHFWO\
LWGRHVQRWWHVWWKH
DFFXUDF\RIWKH6HUYHU
RUWKH([WHQVLRQ