User`s guide

M3000A/M3046A/M3015A/M3016A Service Guide
3-8 Maintaining the Instrument
mended that you replace the Pump and the CO
2
Scrubber at the same time. After fitting the
new part(s), go to Service Mode and reset the appropriate counters. The procedure for reset-
ting the counters is found in "Repairing the Instrument".
General Cleaning of the Instrument
The Monitor, the Measurement Server, and the Measurement Server Extension should be
kept free of dust and dirt. In particular, exterior cleaning of the Monitor’s case and LCD
screen is recommended. Clean the case with a lint-free cloth or sponge, moistened with either
soap and water, a diluted non-caustic detergent or one of the cleaning agents listed in this
chapter. Hewlett-Packard Display Cleaner, HP Part Number 8500-2163 is recommended for
the cleaning of the LCD screen.
&OHDQLQJ*XLGHOLQHV
To avoid damage to the Instrument, follow these cautionary guidelines:
• Do 127 use any Povodine, Sagrotan, Mucocit cleaning agents or strong solvents, for
example, acetone.
• Dilute cleaning agents—Most cleaning agents must be diluted before use. Always dilute
according to the manufacturer’s instructions.
• Never use abrasive materials, such as steel wool or silver polish.
• Do not allow any liquid to enter the case. Never submerge any part of the Instrument.
• Do not pour liquid onto the Instrument during cleaning.
• Do not allow any cleaner to remain on any of the equipment surfaces. Wipe cleaners off
immediately.