User`s guide

M3000A/M3046A/M3015A/M3016A Service Guide
2-26 Installing the Instrument
Installing the Tilt/Swivel Mount (M3080A #A14)
The Tilt/Swivel mount can be used in the following situations:
• Screwed directly to a wall.
• Mounted to the GCX Wall Channel #A15 (described in the following section).
• Attached to the Universal Pole Clamp.
• Attached directly to the Monitor.
6FUHZHG'LUHFWO\WRD:DOO
This option is used to mount the Monitor on a wall but to also provide tilt and swivel
capability. To mount the assembly securely, you need 3 screws. These are not provided
because the type of surface dictates the type of screw used.
6WHS Unpack the Tilt/Swivel mount and check all parts are available.
6WHS Remove the adapter plate (this is only necessary for the GCX Wall Channel).
6WHS Secure the rail to the Tilt/Swivel mount with the 2 screws provided.
6WHS Select 3 screws (appropriate to surface material).
6WHS Insert the 3 screws through the screw holes provided in the plate.
6WHS Tighten the screws to secure the mount to the wall.
6WHS Use adjustment knobs to adjust to the required tilt/swivel angle.
Hang the bed hanger over the rail.
Adapter
Plate
Rail