Technical data

90 S:\hp11807a\OPT001\USRGUIDE\BOOK\chapters\descrptn.fb
Chapter 4, Test, Parameter, and Pass/Fail Limit Descriptions
Introduction
Introduction
Tests are a series of measurements, and one or more tests make up a procedure
(
see chapter 2, "Using the Software/HP 8920B or HP 8920A FW Above Rev.
A.14.00"
). While you may change the tests that make up a procedure, you may not
change the measurements the test will perform. Generally, the order in which the
tests are run is not important.
This chapter describes each test and the associated test parameters, pass/fail
limits, and external equipment that are required. When you first load a test
procedure or create a new test sequence, refer to this section to understand what
test parameters and pass/fail limits are required for each test.
Tests are derived from the following industry standards:
• EIA – Electronic Industry Association, FM test pass/fail limits,
EIA/TIA-603
EIA/TIA-204-D (TEST_19. RX Variation of Sens with Freq)
NOTE: Refer to chapter 2 in this manual for details about customizing a Test Procedure for testing
your FM radio.