Technical data

78
S:\hp11807a\OPT001\USRGUIDE\BOOK\chapters\softbw14.fb
Chapter 3, Using the Software/HP 8920A FW Rev. Below A.14.00
Customizing Testing
Changing Pass/Fail Limits (Edit Specifications)
Specifications are values that set pass/fail limits for tests. Default values are
available in the test software. These default values may be changed to suit your
particular requirements.
The following describes how to change the pass/fail (upper and lower) limits in
the HP 8920A,D
Edit Specification screen. See "Pass/Fail Limit
Descriptions (specifications)," in chapter 4, on page 144
for descriptions for each
specification. For information on saving customized specifications,
see "Saving a
Test Procedure Using the Procedure Manager" on page 83
.
How to Change Pass/Fail Limits