Technical data

45
S:\hp11807a\OPT001\USRGUIDE\BOOK\chapters\softav14.fb
Chapter 2, Using the Software/HP 8920B or HP 8920A FW Above Rev. A.14.00
Customizing Testing
Changing Pass/Fail Limits
Pass/Fail limits define the values a measurement’s result is compared against to
determine if the UUT meets its specified standards. Default values are set in the
test software. These default values may be changed to suit your particular
requirements.
The following describes how to change the pass/fail (upper and lower) limits.
See
"Pass/Fail Limit Descriptions (specifications)," in chapter 4, on page 144
for
descriptions of each pass/fail limit. For information on saving customized pass/
fail limits, see
"Saving a Test Procedure" on page 50.
How to Change Pass/Fail Limits