Technical data

Index
265
S
save, 255
SAVE IBASIC command, 187
Save Proc, 236
SAVE registers lost, 242
saving
procedure, 50, 83
test procedure, 50
test results, 189
saving a procedure, 225
secure frequency information, 143
SECURE IT ROM program, 228
securing a procedure, 228
security
for the radio, 143
select, 186, 255
sensitivity
audio, 119
audio squelch, 160
for the microphone, 172
microphone, 97
microphone, set and measure, 139
reference, 128
testing, 131
threshold squelch, 154
usable set and measure, 130
sequence
changing, 34
editing, 68
general description, 34, 68
saving, 50, 83
serial port connections
figure, 233
serial printer, 215, 243
serial printer connections, 213
Signal-to-Residual Output Power Ratio,
155, 156
SINAD, 255
at opening, 151
at the CDCSS opening, 107
at the CTCSS opening, 107
measured in usable sensitivity test, 104
SINAD level
is within specified limits, 130
receiver usable sensitivity, 131
Sngl Step, 236
softkeys, 236, 255
software
features, 19
how to load, 31, 65
loading, 28, 62
overview, 26, 60
stopping the, 211
software revision A.xx.xx
printer setup, 215
special display conventions used, 186
specifications
editing values, 45, 78
general description, 45, 78, 210
saving, 50, 83
specifying channel information
general description, 38, 72
squelch
CDCSS, 247
CTCSS, 247
squelch blocking, 160
for the receiver, 125, 157
while testing receiver, 125
squelch blocking test
for the receiver, 106
squelch control
for the receiver, 126
is adjusted during testing, 119
squelch knob, 127
squelch preset only
for the receiver, 127
squelch sensitivity
finding the, 123
squelch tone
opening level, 154
SRAM, 255
memory cards, 203, 204
standard RF input level
for the receiver, 128
standard RF signal
for audio distortion, 102
standards
for FM tests, 90
stand-by current drain
for the receiver, 158
stand-by current drain test, 91
steady-state deviation, 94
step size
for audio-frequency response, 133
Stop Test, 236
stopping a test, 211
stopping the program
using Test Execution Conditions, 54,
87, 234
structures improperly matched
error, 241, 242
supply voltage
the test parameter for normal value, 117
sweep step frequency
for modulation limiting, 140
system deviation, 114