Technical data

244 S:\hp11807a\OPT001\USRGUIDE\BOOK\chapters\problems.fb
Chapter 6, Problem Solving
If the printer does not print the test results
If you have an HP 8920B or HP 8920A,D with firmware above revision A.14.00
AND you are using software with Revision B.xx.xx
1. Press TESTS.
2. Select Printer Setup from the SET UP TEST SET list.
3. Check that Printer was selected in the Output Results To:.
4. Check that the test set is correctly configured for HP-IB or serial printing:
a. Select Model and choose the most compatible printer model from the
Choices menu.
b. Select Printer Port and choose which printer port you are using.
c. If the HP-IB port was selected, check that the correct Printer Adrs was
entered.
d. If the Serial port was selected, check that the I/O CONFIGURE screen has been
set up correctly for the printer’s baud rate, parity, and so forth.
Refer to the test set’s User’s Guide for details about configuring the printer.