Technical data

241

S:\hp11807a\OPT001\USRGUIDE\BOOK\chapters\problems.fb

Chapter 6, Problem Solving

If the test procedure doesn’t run on an test set

❒ Check to see that the memory card is correctly inserted into the test set.

❒ Check to see that a test procedure file has been loaded into the test set.

In the upper left corner of the TESTS (Main Menu) screen, a file name should be seen

in the Select Procedure field. If the field is blank, then a test procedure file has

not been loaded.

To load a test procedure file:

1. Press TESTS.

2. Position the cursor to the Select Procedure Location (or Location) field

and choose Card from the Choices menu.

3. Position the cursor to the Select Procedure Filename (or Procedure)

field and choose the test procedure file you want from the Choices menu.

❒ Check that you have selected k1 (Run Test) to start testing.

❒ Check the MESSAGE screen to see if an error is causing the test procedure to not run.

If you see the error message “Structures improperly matched” or “Improper context

terminator”, the software program was incorrectly loaded into the test set. In this case,

refer to the directions on the next page.

NOTE: Test procedure files are not the actual code or program needed to run the tests. You’ll need

to load the test procedure file, then run the selected tests with the memory card containing

the program code inserted in the memory card slot. The program code remains loaded in

the test set until another program is loaded.